Four kinds of fishing float float on floating fish

In bad weather conditions, excessive fish density, or other factors, the fish will leave the waters of daily life and float to the upper and middle layers of the water. Therefore, when fishing, pay close attention to the situation of the fish and find that the fishing port at the bottom is not good. In the meantime, we must change the fishing water layer in time. With the fish fishing activities, we will have a good harvest. Here, we will talk about different drifting techniques in different situations.

First, there are three kinds of fishing methods commonly used for floating fish when the fish condition changes.

1, first of all, said that under the bottom of the fishing, if the underlying activities of the fish slowly go up, and the magnitude of the float is not very large, usually according to the situation off the bottom fishing 5-20 cm.

2, if you find the bottom of the fish appear more obvious floating, hook bait into the water after the mid-level often appear in the water, then explain the fish has been in the middle activities, this time you can find the fish mouth to determine the fishing water layer, that is Fishing half a water.

3, if just throwing oysters did not take long, the fish appeared when the float just entered the water, sometimes the floats did not stand upright there has been an abnormal action, this time the fish has been active in the surface of the water, you can use the fly fishing method.

Second, fishing off the bottom

1. After hooking the lure in normal fishing, after a long time no fish movement was observed, and frequent movement occurred at a place about ten centimeters from the bottom, meaning that the fish began to change the water layer activity, and at this time, it could change from the previous fishing ground. To fish off the bottom.

2, first keep the state of the bottom of the same, pull the float down, test how long the fish pull down from the bottom how long, and then put the float into the water, and then according to the appropriate conditions to trim the weight of the lead, let the float Exposing the fishing line before the bottom.

3. When judging the fish's distance from the bottom, it mainly depends on the fishing experience accumulated on weekdays, and it is determined by repeatedly searching for fish in different water layers. When the fish swimming layer changes, it is necessary to throw fish to find the fish mouth several times. Don't take too much trouble. Only by finding the water layer where the fish is active can you improve the catch. The quality of the fishing rod used should be lighter, and it is convenient to control it to facilitate throwing and control rods, saving physical strength.

Third, fishing half aqua

1, when the fishing float actually did not have too much stress with the bottom of the fishing, such as middle of the fishing, you can empty hook leveling water, and then put the hook into the water thrown into the bait, appropriate trimming lead, let Double hook bait suspended in water.

2, this fishing method, after the float into the water will quickly turn over in place, have a great effect on the middle layer of fishing, if the float to accelerate the sinking or pause before reaching the set of fishing items and the top of the float, usually It is the performance of the mid-level fish cuttings. At this time, the fish can be used as a fishing rod, and it is best to use a float with clear target and accurate movement.

Fourth, fly fishing method

1, the fish pool in the competitive pool is very dense, so fly fishing has become a very popular fishing method, for example, if you catch half a water before, if you fly fishing lead is very simple, push the lead sinker into the float seat below That's it. This adjustment will make the float float faster in the water, and it will extend the length of the hook bait in the water.

2. Since the plumb bob is moved to the floating seat, the gravity is concentrated on the float. When the float floats into the water, it will quickly turn over due to the gravity of the float sink. However, when the sinker is moved to the float seat, it will be longer. The length of the strand, the strand is less affected by the plumb, the hook bait will be hem will be slower for a long time, use a good quality of the strand, after entering the water to ensure its soft and delicate characteristics, do not use poor fishing The line will affect the lure effect.

3, this will give the middle of the fish have enough time to bait, but this fly fishing method is mainly in the state of fishing half of the water changed, it is usually applied in the upper angling.

Fifth, the whole swimming layer fly fishing method

1. The fly-fishing method in the entire swimming pool differs from the above-mentioned fly-fishing method in that it is a change made at the time of the bottoming. The lead is also pushed under the lead sheet seat to accelerate the speed of the float to float.

2, but the difference is that although it also affects the speed of hook bait, but the final hook bait will fall to the bottom of the water, this will give the entire water layer of fish enough time to find food, enhance the fish mouth, So even if there is no fish bite in the upper middle, it will eventually fall to the bottom of the fish.