First, the constant temperature and humidity test chamber humidification over-temperature protection has a fault: it may be due to the lack of water in the humidifying tank and the over-temperature adjustment caused by improper adjustment. The general adjustment is in the range of 120 degrees Celsius to 150 degrees Celsius. If it is a humidifying tank. If there is water shortage, please check the water level of the humidification supply cylinder.
Second, the compressor over-current protection fault: check whether the transition protection relay of the compressor is relatively small or the fan that dissipates heat from the compressor is broken. If any of these faults occur, please contact a professional manufacturer.
Third, the pump has not broken: check whether the pump is broken or the pump overcurrent protector current is too small, appropriate adjustment current protection can be.
Fourth, lack of water protection: the following water tank is short of water, it is necessary to add water tank to fill the pure water or the water tank is not cleaned for a long time so that the floating ball in the tank can not be lifted, please clean the water tank until the float It is best to be able to move up and down freely.
Solution
First, check if there is water in the water tank. The water level can be below two-thirds of the water tank. The water must use pure water or distilled water.
Second, check if the wet ball gauze is hung above the wet bulb sensor.
Third, if there is an error between the actual temperature and humidity and the set value, it is necessary to replace the gauze on the sensor in time to ensure the accurate operation of the constant temperature and humidity test chamber.
Face Skin Rejuvenation is a cosmetic treatment, which aims to restore a youthful appearance to the human face.
One of the best treatments available for enhancing and maintaining the youthful beauty of your face is Dermal Fillers.
Reborn PLLA Dermal Filler is a safe, biocompatible material that is injected below the surface of the skin in the area of fat loss and skin depressions. It provides a gradual and significant increase in skin thickness, improving the appearance of folds and sunken areas. No skin testing is required. The primary component is poly-l-lactic acid.
Tiny PLLA Microspheres Particles: 3-10um
Shorter dissolve time – in 10 minutes
Suitable for face(except the red area in the lip and the area in nose,neck,hand,breast,genital,stretch marks,and buttock.Especially Reborn plla is very suitable for thin area, such as under eye, forehead, lacrimal groove...
Long duration – more than 2 years
Contents: 150mg/vial, 240mg/vial,360mg/vial,500mg/vial
Reborn PLLA Hydrogel is for Mesotherapy. Mainly for fine wrinkles and facial texture improvement.
Content: 5ml/vial
It can make the skin white and tender, replenish lost water and collagen, awake the cell regeneration function, repair the withered cells of the skin, shrink of enlarged pores, reduce discoloration, patch of acne pits.
Hyaluronic Acid Injections For Face,Under Eye Dermal Fillers,Cheek Dermal Fillers,Dermal Fillers For Acne Scars
Rimless Industry Co.,Ltd. , https://www.rimlessmedbeauty.com