[ Chinese wardrobe net ] Wardrobe is a household appliance that we must use, but there are many kinds of wardrobes. The cheapest wardrobe is the cloth wardrobe. The price of this wardrobe is relatively cheap, and the structure of the cloth wardrobe is very simple, but The assembly of the cloth wardrobe is not very simple. What is the specific assembly procedure for the cloth wardrobe?
Cloth wardrobe assembly steps - check the packaging
First of all, when receiving the goods, whether it is express or direct purchase, be sure to check whether the packaging is seriously damaged. If there is, it is likely that the steel pipe inside is also crushed. Such goods must not be signed and purchased. Check it out clearly.
Cloth wardrobe assembly steps - check accessories
Open the package, and then check whether the accessories inside are complete. There is a manual, check the instructions. If there are few, it is estimated that you can't install it without using it. Therefore, the number of advances is clear, so as not to be wasted. When installing, be sure to wear gloves. And must carefully read the instructions.
Cloth wardrobe assembly steps - the first to install the bottom
First install the bottom one, take out the four-way joint with the bottom and the high, and connect with the short tube in the middle. Install a four-way joint on each side, then install the tube on both sides, decide the position of the place, and install the long tube. Short tube. Then install the base fabric on both sides, and then install a three-way joint around each other .
Cloth Wardrobe Assembly Steps - Set of Wardrobe Cloth
After installing the bottom, insert six short steel pipes, then put the whole wardrobe cloth up against the surrounding holes. Then install a layer of the bottom plate and then put it on the six steel pipes .
Cloth wardrobe assembly steps - short floor
If the wardrobe is divided on two sides, first install the short-side floor, first insert the side steel pipe, then install the cloth, then connect the four-way joint, then install two horizontal steel pipes, then install the cloth, then Then make up the four-way joint on both sides. Repeat the baffle until it is attached to the top .
Cloth wardrobe assembly steps - long steel pipe
After the short-side partition is installed, the long side is a vertical hanging area, and a three-way joint is used to connect the two long tubes to the top .
Cloth wardrobe assembly steps - top steel pipe
After the two sides are installed, connect them directly with long steel pipes, so that the wardrobe is installed. If the wardrobe is too high and not enough to squeeze, it is recommended to push the side backwards so as not to be installed. At the same time, the hanging steel pipe can also be used. The connector is installed, this is relatively simple .
Sofas And Loveseats
Sofas And Loveseats,Sofa And Loveseat Set,Sofa Loveseat Set,Reclining Sofa And Loveseat
Haining SanJose Furniture Co.,Ltd , https://www.jpaifurniture.com