Comprehensive analysis of static fishing float skills

Fishing in the competitive pool is affected by factors such as weather and fish density, and it is often adjusted continuously in the two tactics of fishing float and bottom fishing. In fishing floats, static fishing floats and dynamic fishing floats can be adopted. In this issue, "Fishing on the way," Fanning's teacher will introduce static fishing techniques in detail from principles, fishing methods, and bait matching.

Static fishing principle:

The so-called static fishing float is to trim the lead skin, so that the floating floating force is greater than the sum of all the gravity of the plumb bob, hook, and bait, so that the double bait can be suspended in a fixed layer of water, and the bait can be continuously changed by adjusting the position of the float. The water layer, so as to fish a certain water layer, so that the static fishing float for the high requirements of fishing, we must adjust the appropriate state.

Understand the principle of static fishing floats Many fishing friends may ask, what kind of state will the string group, lead sinker, and bait come into when using static fishing floats? First throw the water into the water, the line group will have the first swing, this time is the center of the floating seat, the distance from the floating seat to the lead skin is the radius, until the float slowly turns upright, this section of the main line completes a fan-shaped pendulum Until the lead sheet seat and the floater are in a straight line and perpendicular to the water surface, the first swing is completed; the next time the strand will perform the second swing, this time with the lead sheet center as the center and the strand The length is the radius, and the bait swings until it is perpendicular to the bottom of the water. It should be noted that after the second swing is completed, the plumb bobs and bait are suspended in the water. The floating and floating force is greater than the gravity of the entire line group, which can reveal a certain number of meshes on the water surface. .

Half-water bait fishing method:

In the static fishing method, semi-water bait can be used to adjust the fishing method. Since in practice fishing is usually started from the bottom, such as starting from 10 cm away from the bottom, During the pre-fishing period, fish was quickly eaten and fished in the water layer set by us. However, if we find that the float has not reached the designated fishing position after fishing for some time, there will be a cut. The signal indicates that the fish is floating above the water layer used for fishing. At this time, it is necessary to pull down the float, so that the entire line group can be increased upward to increase the height of the fishing lure from the bottom, so that the water for fishing can be determined. Floor.

Feed configuration:

White baits are commonly used in competitive pool fishing. The simplest method of bait for this type of bait is to blend snow flakes in a certain ratio of bait to bait. Raw material baits each take one-half, mix well, 1:1 ratio of bait to water, the water absorption of the snowflake bait is very good, stir quickly, let stand for a minute, then the bait is broken up, hit like The wet bean dregs begin to rub, and the hands of the rubbing process do not stick to the water.

Drifting:

When adopting the method of static fishing and floating, we are mainly responsible for signals after the floats are in place. Therefore, there are two common types of rapping: one is the next one after arrival, and whether it is obvious or weak, it can be positive. Hey, especially in the early stages of fishing, the fish must be lured to the water layer for fishing by frequency; the second is the top, because the whitebait has good palatability, so the encounter can also be drowned. If you find that the float is not in place after fishing for a period of time, it often shows a signal of the cutoff. At this time, you can pull the float down to catch more lightly, and then observe the bite hook condition after the float floats into the water and adjust it in time.