Internal dimensions and sheet selection criteria for the overall wardrobe

What are the internal dimensions of the overall wardrobe? What is the standard for the selection of the overall wardrobe?

1. When installing the clothes rail, it should be noted that the clothes rail must be taken according to the actual depth of the wardrobe interior, and the distance above the board must be 4-6 cm. This size must be satisfied because the distance Too short, it will be more difficult to put the hangers in the future; the distance is too long and it wastes space. The clothes rail also belongs to the hardware series. At least two or three screws should be fixed on both sides of the good clothes rail. When positioning the hole, be sure to pay attention.

2. The width of the flat door is 45-60 cm, and the width of the sliding door is 60-80 cm. The pressure of the hinge is not as good as that of the track, so for the swing door, The door panel should not be too wide or too heavy.

3, the installation height of the clothes rail should be the height of the hostess plus 20 cm.

4, the height of the hanging top is between 85-95 cm; the height is 90 cm, the space is more adequate, if you want to be a little looser, add up to 95 cm is almost the same.

5, the depth of the large wardrobe is generally 55-60 cm; if the space is not particularly tight, it is recommended to choose a depth of 60 cm is better, and the charges for 55 and 60 cm manufacturers are the same, but the feeling of hanging clothes is different It is.

6. The height of the hanging coat is enough for 140 cm; the longest hanging gown is less than 140 cm in height, the long down jacket is 130 cm, and the suit is 120 cm long after being stored in the bag.

The selection criteria for the board of the whole wardrobe:

1, different grades, plates are also different

Generally, the cut surface of the sample is seen. From the cut surface, the blockboard is two or four layers of upper and lower boards (also thickened using four or more single boards) close to the solid wood core, the quality of the fine board. The core cut surface is flat and there is no gap; the MDF is pressed by fine fibers, the combination is relatively tight and the weight is relatively large; the particle board is a wooden granular structure, but the combination is not tight enough, the weight is light, and the quality is poor. There are small pores; the multi-layer board is made of a plurality of veneers, generally three or five layers.

2, look for environmentally friendly sheet

Professional custom wardrobe manufacturers use environmentally friendly panels that meet national testing standards, while some manufacturers use inferior panels that have no test reports and pose a potential threat to human health.

3, sheet veneer to see the quality

Some wardrobes look good on the surface, however, with a light stroke, you can draw obvious scratches. These custom-made wardrobes are made of surface-coated vellum paper or ornate paper sheets that are often used in low-cost wardrobes on the market, and have poor wear resistance.

4, sheet edge sealing to see work

Professional custom-made wardrobe manufacturers use precision panel saws to cut sheets, and there is no chipping around the sheets. After the edges are sealed, the water in the air is effectively prevented from intruding into the interior of the board. Some manufacturers have no professional equipment, rough cutting, and obvious edge collapse around them. Some even cut corners and only cut one side of the front side of the board. The unsealed surface easily absorbs moisture from the air, causing the sheet to swell, causing the wardrobe to deform and affecting the service life.

Ergonomic Desk

Ergonomics has an important impact on product design, which directly affects the experience of product use; therefore, in product design, designers try to adhere to the principle of "humanization", so as to conform to the theory of ergonomics, so as to improve the comfort and experience of product use.

This desk is designed with automatic lifting function and ergonomic design. At the same time, the hand controller also has multiple memory keys storage function, which can reach the height you want with one key.

7 2

Ergonomic Office Desk,Adjustable Ergonomic Desk,Ergonomic Standing Desk,Ergonomic Height Adjustable Desk,Standing Desk

Suzhou Uplift Intelligent Technology Co., Ltd , https://www.officestandingdesk.com

Posted on