The use of inkpads is very common in office life. Ink must be used when stamping, but can the newly purchased inkpad be used directly? Especially if you buy ink in the cold winter, can you use it directly? The following small series to explain to everyone that the newly bought ink can be used directly!
Can the newly bought ink be used directly?
    The ink is mainly composed of cinnabar, wormwood and ink. The quality of cinnabar is heavier than oil. Can the newly bought ink be used directly? It is easy to produce oil when the ink is left for a period of time, so it must be stirred at regular intervals to maintain the best quality. As long as the ink is slowly mixed in the same direction, the original softness and roundness of the ink can be restored.
    When the weather is cold, the ink is easy to dry and the softness is not enough. So the newly bought ink can be used directly? Before using the ink, it is recommended to take about 10 minutes in the sun. When there is no sun, you can use a hot air gun or a household hair dryer to heat around the ink pad. When the temperature rises, the ink pad will naturally become softer and the effect will be more ideal.
    Before use, use the ribs (one or both ends of the flat special stir bar, can be replaced by similar items) to flip the ink in the ink tank up and down, so that the mud is even, and then the side is pulled from the bottom to the diagonal Press the direction into the mud group, pay attention to the side pressure, do not pick or provoke too high, and at the same time, follow the trend in the same direction to roll over the entire Indian mud group. Turn the ink tank to change the pick position and repeat it in the same direction several times until the ink is piled into a spherical shape at the top. The purpose of the pile is to homogenize the composition of the ink, and the moxa is basically arranged in the same direction, avoiding the use of the moxa in the process of being pulled out and affecting the printing effect. It also thickens the body of the ink, generates a certain amount of stress inside, and rebounds well. After adjusting, it is best to let it sit for several days, so that the air that is entrained during the preparation is naturally discharged, and the mud is more dense and smooth.
    When the seal is used to capture the ink, it should not be directly poked. It must be held in a stable mud box, and a hand-held chapter is used to make the printed side of the printed surface touch the pile of ink on the top of the round, and touch it, and then turn the seal and make the seal. First, the order in the middle and the middle is evenly covered with ink. It is better to beat it several times. When the printing surface is flat, the thickness of the upper Zhu directly determines the effect of the imprinting, and should be preceded by the need to accumulate experience. For new seals, be sure to remove the stone chips to avoid falling into the ink pad. If the new pile of ink is not determined to be bundled, the mud head should be pressed and then continue.
    The above is the answer to the newly bought ink pad. We must pay attention to the preservation of the ink when using the ink.
Hanging Chair,Hanging Basket Chair,Swing Chair Garden,Outdoor Hammock Chair
Foshan Shunde Zhili Furniture Company , https://www.zhilioutdoor.com